Hitachi Koki SP 18SB Manual De Instrucciones E Instrucciones De Seguridad página 7

9. Keep all screws, bolts and covers tightly in place.
Keep all screws, bolts, and plates tightly mounted. Check their condition periodically.
10. Do not use power tools if the plastic housing or handle is cracked.
Cracks in the tool's housing or handle can lead to electric shock. Such tools should not
be used until repaired.
11. Blades and accessories must be securely mounted to the tool.
Prevent potential injuries to yourself or others. Blades, cutting implements and
accessories which have been mounted to the tool should be secure and tight.
12. Keep motor air vent clean.
The tool's motor air vent must be kept clean so that air can freely flow at all times.
Check for dust build-up frequently.
13. Operate power tools at the rated voltage.
Operate the power tool at voltages specified on its nameplate.
If using the power tool at a higher voltage than the rated voltage, it will result in
abnormally fast motor revolution and may damage the unit and the motor may burn
out.
14. NEVER use a tool which is defective or operating abnormally.
If the tool appears to be operating unusually, making strange noises, or otherwise
appears defective, stop using it immediately and arrange for repairs by a Hitachi
authorized service center.
15. NEVER leave tool running unattended. Turn power off.
Don't leave tool until it comes to a complete stop.
16. Carefully handle power tools.
Should a power tool be dropped or struck against hard materials inadvertently, it may
be deformed, cracked, or damaged.
17. Do not wipe plastic parts with solvent.
Solvents such as gasoline, thinner benzine, carbon tetrachloride, and alcohol may
damage and crack plastic parts. Do not wipe them with such solvents.
Wipe plastic parts with a soft cloth lightly dampened with soapy water and dry
thoroughly.
18. ALWAYS wear eye protection that meets the requirement of the latest revision of ANSI
19. ALWAYS wear a mask or respirator to protect yourself from dust or potentially harmful
particles generated during the operation.
20. NEVER place hands or body parts near the accessories attached to the polisher during
operation.
21. NEVER use accessories which are broken or deformed or worn away.
22. NEVER use the polisher in places where the sparks generated by the polisher can cause
explosion, such as where flammable materials or gases are present.
23. NEVER push in the lock lever while the spindle is running.
24. ALWAYS firmly grip the body handle and side handle while operating the polisher.
Standard Z87.1.
English
7