mybeo BITE HELPER Manual Del Usuario página 21

• If the temperature sensor measures an abnormal temperature value for
about 5 seconds in the various modes, the blue status LED flashes for 30
seconds and the vibration, light ring and heating plate switch off and the
unit goes into shutdown mode.
• When a low battery condition is detected with the illuminated ring on in
40°C, 45°C and 50°C modes, after the red status LED flashes rapidly for
30 seconds, turn off the illuminated ring, vibration and heating and the
unit will go into shutdown mode.
5.1 Charging
Use the microUSB cable to connect the power supply unit to the insect bite
healer. Connect the power supply unit to a properly connected socket. Pay
attention to the information on the rating plate.
• Charging: The pink status LED flashes.
• Charging completed: The pink status LED is permanently on.
6. Cleaning and care
It is recommended to clean the appliance before first use and before each
subsequent use. Make sure that the appliance is switched off and has cooled
down before cleaning. Use a dry soft cloth for cleaning. Never use substances
that could be toxic to the skin or mucous membranes. Do not use harsh or
chemical cleaning agents. Never immerse the appliance in water.
7. Safety instructions and disclaimer
Never attempt to open the unit to carry out repairs or modifications. Avoid
contact with the mains voltages. Do not short-circuit the product. The unit
is not waterproof. Please use it only in dry conditions. Protect it from high
humidity, water and snow. Keep the unit away from high temperatures.
Do not expose the unit to sudden temperature changes or strong vibrations
as this may damage the electronic parts. Check the unit for damage before
use. The unit should not be used if it has been knocked or damaged in any
way. Please observe the national regulations and restrictions. Do not use
the appliance for purposes other than those described in the instructions.
This product is not a toy. Keep it out of the reach of children or mentally im-
English
21