Locating The Loophear; Using The Loophear; Turn The Loophear Tm On; Turn The Loophear Tm Off - Geemarc loopHEAR Guia Del Usuario

INSTALLATION
Please use the strain relief mechanism as displayed. This provides extra
protection for the cable at the connection point. It will extend the life of the
power cable and reinforce the connection to the equipment.
TM
The loopHEAR will need to charge for 4 hours before its first use. The
power indicator will blink red whilst the battery is charging. When the
power indicator is blinking green, the battery is fully charged.

Locating the loopHEAR

TM
In order to receive the optimal sound from the loopHEAR
location is facing the user. There are two options when locating the
TM
loopHEAR .
Fully Portable
TM
The loopHEAR can be used as a fully portable unit with or without the
base plate attached. It can be used in a variety of locations with no setup
required and can be used immediately.
Semi Fixed
If you want to ensure the loopHEAR
used as a semi fixed unit as follows:
1) Choose the location to fix the loopHEAR
range of coverage available (see below). Ensure you make full use of it
2) Remove the base plate – as described in Battery Charging above
3) Screw the base plate to the table or desktop with the screws provided
4) Replace the base plate – as described in Battery Charging above
LH100
1m
60°
TM
, the ideal
TM
stays in one place then it can be
TM
. Please bear in mind the
9

USING THE loopHEAR

Turn the loopHEAR TM On
Turn the power switch found at the rear of the unit to the I position. The
power indicator lights up (solid green if the power adaptor is not plugged in,
blinking green if it is plugged in).
When the battery is weak, the indicator will light up red (solid red if the
power adaptor is not plugged in, blinking if it is plugged in).
Plug in the power adaptor to recharge the battery.
Turn the loopHEAR TM Off
After use, turn off by setting the power switch at the back of the unit to the
0 position.

Using the Headset

A headset is supplied for hearing impaired
users who do not use a hearing aid or do
not have a 'T' switch on their hearing aid.
Simply, plug the headset into the
HEADSET jack (3.5mm), found at the rear
of the loopHEAR
be adjusted by using the volume knob also
found at the rear of the unit (turn knob
clockwise to increase volume).

Using the External Microphone

Plug the supplied microphone into the MIC JACK at the back of unit. The
external microphone will now override the built-in microphone.
The external microphone has a
clip. This is extremely useful for
attaching to your lapel as
illustrated. The external
microphone can also be wall
mounted with the wall clip
supplied.
TM
TM
unit. The volume can
10