Publicidad
Idiomas disponibles
Idiomas disponibles
English
Turntable Operation
1. Press the Power Switch to turn on the power.
2. Rotate the Function Knob to either 33
turntable speed accordingly. Use the 45 RPM Adapter if necessary
3. Place the record on the turntable.
4. Remove the stylus protector from the stylus assembly.
Note: To avoid stylus damage, make certain the included stylus guard is in place
whenever the turntable is being moved or cleaned.
5. Release the Tonearm Clip.
Note: when the turntable is not in use, remember to lock back hold down clip.
6. Use the Tonearm Lever to lift up the tonearm.
7. Gently move the tonearm over the record where play is desired to begin. Set
the Tonearm Lever back to the down position, the tonearm will descend
slowly onto the record and begin to playback.
8. When the record is finished playing, use the Tonearm Lever again to raise the
tonearm and then return it to the Tonearm Rest. Release the lever to let the
tonearm sit back at its rest. To suspend the playback, repeat the same steps.
9. Lock the Tonearm Clip to secure the tonearm.
Cartridge Replacement
1. Before replacement, put the stylus protector back on the stylus to prevent
damage to the stylus during the replacement process.
2. Carefully remove the wire leads from the original cartridge.
3. Loosen the two screws on the headshell that are securing the cartridge and
then remove the original cartridge.
4. Mount the new cartridge to the headshell and tighten it lightly. Do not
completely tighten the screws at this moment.
5. Connect the wire leads to the new cartridge's terminals .The wire lead color
codes are as below:
Red
Blue
White
Yellow
6. Adjust the cartridge's position to make sure it is precisely aligned on the
headshell so that the stylus will be tracking the grooves in parallel perfectly.
To achieve this, place the included paper cartridge alignment protractor over
the turntable spindle, carefully lift the tone arm and place the tip of the stylus
on the points marked 130mm and 250mm respectively. Fine tune the
cartridge's position on the headshell until the cartridge is perfectly in parallel
with the reference lines at both points.
7. Tighten the screws completely once the perfect alignment is achieved.
Left channel positive
Left channel negative
Right channel positive
Right channel negative
1
/
or 45 RPM mode to select the
3
(L+)
(L–)
(R+)
(R-)
7
Publicidad
