Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Conductivity test
Connect the red cable to the jack marked VΩ. Connect the black cable to the jack marked COM. The meter will
recognise that conductivity is being measured. During conductivity measurement, the built-in buzzer will emit a
sound signal and the built-in indicator light will illuminate whenever the measured impedance drops below 50
Ω. It is absolutely forbidden to test conductivity in circuits through which electric current is fl owing.
MAINTENANCE AND STORAGE
Wipe the meter with a soft cloth. Larger amounts of dirt should be removed with a slightly damp cloth. Do
not immerse the meter in water or any other liquid. Do not use solvents, or corrosive or abrasive agents for
cleaning. Care should be taken to keep the contacts of the meter and the measurement cables clean. Clean
the contacts of the measurement cables with a cloth slightly soaked in isopropyl alcohol. In order to clean the
contacts of the meter, turn off the meter and remove the batteries. Turn the meter over and shake it gently so
that larger pieces of dirt fall out of the meter connectors. Lightly soak a cotton swab in isopropyl alcohol and
clean each contact. Wait for the alcohol to evaporate and then install the batteries. The meter should be stored
in a dry room, inside the supplied unit packaging.
O R I G I N A L
I N S T R U C T I O N S
14
Publicidad
