Publicidad
Idiomas disponibles
Idiomas disponibles
2. From the inside of the
dispenser, insert the key into
the back of the dispenser in
the key slot and push until the
latch piece is ejected from
the bottom of the dispenser.
(See Figure 17)
3. Re-install the latch piece in
the bottom of dispenser with
the slotted side away from the
wall and toward the front of the
dispenser. Push the latch piece
into the dispenser until it snaps
into place. (See Figure 18)
Figure 18
4. To close the dispenser, place your hand on top or
front of the dispenser below the push pad, and push
up on the cover until it is latched. (See Figure 19)
NOTE: Do not close by pushing on push pad!
5. To open, insert key into slots of the release latch on
the bottom of the dispenser and push the key up.
Place your other hand on top and guide the front
cover forward. (See Figures 20-21)
Figure 20
NOTE: The dispenser can be converted back to
the no key required mode. Complete steps 2-3
and insert the latch piece with the slotted side
toward the wall.
PAGE 3 OF 12
INSTALLATION CONTINUED
Figure 17
Figure 19
Figure 21
LOADING THE DISPENSER
1. Open by pushing up on the release latch (use key
if you have converted to the keyed locking mode).
The latch is on the bottom back edge in the center.
While pushing the release latch, open by placing
your other hand on the top, and guide the front
cover forward. (See Figures 22-23)
Figure 22
2. Hold bag with label toward back. Load bottom of
bag into dispenser. Slide the bag collar over the
guide and push. Ensure the bag collar is completely
inserted in the collar guide. (See Figures 24-25)
Figure 24
3. Remove the protective overcap from the pump.
To close the dispenser, place your hand on top or
front of the dispenser below the push pad, and push
up on the cover until it is latched. (See Figures 26-27)
Figure 26
NOTE: Do not close by pushing on push pad!
Figure 23
Figure 25
Figure 27
0324 IH-3415
Publicidad
