Festool TS 75 EQ Manual De Instrucciones página 11

Multifunction table
16
The mutifunction table, which is available in two
sizes (MFT 800, MFT 1080), makes clamping the
workpiece easy and allows you to saw large and
small workpieces safely and precisely using the
guide system. Its many fi elds of application make
economical and ergonomically convenient work
possible.
Guide system
The guide rails, which are available in different
lengths, allow for precise, clean cuts and
simultaneously protect the workpiece surface
against damage. In conjunction with the extensive
range of accessories, exact angled cuts, mitre
cuts and fi tting work can be completed with the
guide system.
17.1
The option of securing using G-clamps (17.4)
ensures a fi rm hold and safe working. The optional
cord guide (17.2) prevents the power cord and
vacuum hose from catching on the end of the
guide rail.
The guide clearance of the saw table on the
guide rails can be set with the two setting jaws
(17.1).
The guide rails are equipped with a splinterguard
(17.3, 18.1), which prevents splintering of the
workpiece by holding the top edge of the workpiece
down as the teeth of the sawblade move upward
against it. The spliterguard has to be cut to size
before the fi rst use:
- Set the speed of the machine to level 6,
- Place the machine on the rear end of the guide
rail,
- Switch the machine on, press it down to the set
cutting depth and cut the splinterguard along
the full length without interruption. The edge
of the splinterguard now corresponds exactly to
the cutting edge.
18.1
The splinter guard needs to be replaced if it
becomes damaged or worn:
- Peel the original splinter guard (18.1) away from
the guide rail.
- As needed, clean residual adhesive and debris
from the guide rail.
- Peel off the plastic backing from the new splinter
guard to expose the adhesive.
17.3 - Without stretching the rubber, carefully place
the new splinter guard on the underside of the
guide rail tight to the alignment rib (18.2).
- Make sure the splinter guard is fi rmly pressed
down to the guide rail.
17.2
- Trim the splinter guard as described before.
Saw blades, other accessories
In order to be able to saw different materials
quickly and cleanly, Festool offers saw blades that
are specially designed for your machine.
The order numbers for the saw blades and other
17.4
accessories can be found in the Festool catalogue
or on the Internet under www.festool-usa.
com.
11
18.2