Technical Data; Symbols; Functional Description; Use For Intended Purpose - Festool TS 75 EQ Manual De Instrucciones

Technical data

Power consumption
No load speed
Angele of cut
Depth of cut at:
90°
45°
Saw blade diameter
Saw blade hole diameter
Weight
Safety acc. to UL 60745, CSA C22.2 No. 745

Symbols

V volts
A amperes
Hz hertz
W watt
~ alternating current
n no load speed
0
Class II Construction
rpm revolutions per minute

Functional description

1.1
1.2
1.3
1.4
1.5
1.6
1.1 Protective cover
1.2 Cutting depth scale
1.3 Cutting depth end stop
1.4 Setscrew for angle adjustment
1.5 Hexagon socket wrench
1.6 Saw table
1.7 Switching on and unlocking block
1.8 On/Off switch
1.9 Guide jaws

Use for intended purpose

The hand-operated circular saw TS 75 EQ is
designed exclusively for the sawing of wood,
1 600 W
1350 - 3550 rpm
0° - 45°
75 mm (3.0")
56 mm (2.2")
210 mm (8.27")
30 mm (1.18")
6.1 kg (13.4 lbs)
1.7
1.8
1.9
5
wood-like materials and plastics. With the special
saw blades for aluminium offered by Festool,
these machines can also be used for sawing
aluminium.
The machine should not be converted or modifi ed,
e.g. for any other form of use, other than as
specifi ed in these operating instructions.
The user shall be liable for damages
and accidents resulting from incorrect use.

Electrical connection

The network voltage must conform to the voltage
indicated on the rating plate. A 16 A safety fuse
(for 120 V) or a corresponding protective circuit-
breaker is required.
See the following fi gure for connection and dis-
connection of the power cord.
Always switch the tool off before con-
necting or disconnecting the power cord!
2
Extension cable
If an extension cable is required, it must have
a suffi cient cross-section so as to prevent an
excessive drop in voltage or overheating. An
excessive drop in voltage reduces the output and
can lead to failure of the motor. The table below
shows you the correct cable diameter as a function
of the cable length for the TS 75 EQ. Use only
U.L. and CSA listed extension cables. Never use
two extension cables together. Instead, use one
long one.
Total Extension Cord
Lenght (feed)
Cord size (AWG)
Note: The lower the AWG number, the stronger
the cable.

Tool settings

Always disconnect the plug from the
power supply before making any adjustments
to the circular saw or installing or removing any
accessory!

Electronic control

The TS 75 EQ has solid shaft electronics with the
following functions:
25 50 100 150
14 12 10 -