Publicidad
Idiomas disponibles
Idiomas disponibles
3.
Remove the plugs, nuts, and gaskets, and secure the mounting bracket to the plugs.
4.
Place the gaskets on the plugs and tighten the nuts. Make sure that the installation has
been carried out correctly, otherwise the fan may fall down. Fig. 5
5.
Align the holes in the blades with the holes in the motor and fix the blades. Fig. 6.
6.
Pass the canopy through the cover of the downrod, then pass the power cables through
the downrod.
7.
Loosen the downrod base fixing screws and align the holes in the downrod with the
holes in its base. Then, fit the pin and clevis. Use a flat screwdriver to tighten the
screws at the base of the downrod. Fig. 7
8.
Fit the downrod cover.
Note: make sure that the pin and clevis are correctly positioned to prevent the fan from
falling.
9.
Grasp both sides of the lamp body with both hands, align the downrod with the hole in
the mounting bracket and then fit the mounting bracket. Fig. 8
10. Turn the lamp body counterclockwise until it is in the correct position. Move the lamp
body to the right and to the left to ensure that it is correctly positioned.
11.
Insert the controller into the mounting bracket. Fig. 8
Wiring connections. Fig. 9
12.
Connect the white plug of the controller motor wires to the white plug of the ceiling fan
motor wires.
13.
Strip the power cable (N: neutral, L: line) by 6 to 8 mm.
14. Connect the neutral/line input wire from the controller, the earth wire from the
mounting bracket, and the earth wire from the ceiling fan to the appropriate wiring
holes on the mounting bracket. Afterwards, tighten the screws of the wiring terminals
with a flat screwdriver.
15.
Connect the neutral/line cable and the earth cable to the corresponding wiring holes
on the mounting bracket. Afterwards, tighten the screws of the wiring terminals with a
flat screwdriver.
16.
Arrange the cables.
Note: the remaining length of the cables can be placed in the cover of the mounting bracket. If
the cables are too long, cut them.
17.
Loosen the fixing screws of the mounting bracket canopy by 2 to 5 mm. Then, hold the
canopy with both hands and carefully insert the fixing screws into the mounting holes.
18. Turn the canopy counterclockwise until it is in the correct position.
19.
Tighten the canopy fixing screws with a flat screwdriver. Fig. 10
ENGLISH
ENERGYSILENCE AERO 5270
45
Publicidad
