Publicidad
Idiomas disponibles
Idiomas disponibles
3
Install new receiver logic board
3.1 Connect the wire harnesses to the
new receiver logic board. When
reconnecting the wire harness, be sure
the tabs on the wire harness are facing
the end panel, not the logic board.
NOTE: If you have model
8365W-267 or 8365WRGD-267,
remove the plastic post off the
end panel for the logic board
to seat properly or order a
replacement part end panel, part
number 041D0210-1.
End Panel
Wire
Harness
Logic Board
Wire Clip
Tabs
NOTE: A test of the safety reverse system is necessary for safe operation.
Programming
1
Program a remote control using the learn button
1.1 Press and release the Learn button on the garage door opener. The Learn indicator light
will glow steadily for 30 seconds.
To program the Wi-Fi garage door opener to your network refer to your owner's manual.
3.2 Insert the antenna wires through
the holes in the end panel. Snap the
receiver logic board into place on the
end panel and fasten with screws.
Antenna wires
Reconnect the end panel to the garage
door opener.
NOTE: Some models
Antenna
will require the short
wires
antenna wire to be
placed in the traps of
the end panel.
Learn
Indicator
Light
Yellow Learn
Button
3.3 Reinsert the wires.
Door control wires:
• white wire into the white terminal.
• white/red wire into the red terminal.
Safety sensor wires:
• white wires into the white terminal.
• white/black wires into the
grey terminal.
To insert or remove the
wires from the terminal,
push in the tab with a
screwdriver tip.
1.2 Within 30 seconds, press and hold the
button on the remote control.
2
3.4 Install the light lens by aligning with
the hinges and snapping into place.
Reconnect power.
NOTE: When installing the light lens, ensure the antenna
wires are hanging straight down.
1.3 Release the button when the garage
door opener light blinks. It has learned
the code. If light bulbs are not installed,
two clicks will be heard.
Publicidad
