Publicidad
Idiomas disponibles
Idiomas disponibles
USE
Cooling Mode
In this mode, the exhaust hose must be connected to the outside of the home.
1 - Press the
button on the control panel or on the remote control to turn on the device
2 - Press button
on the control panel or remote control several times to light up LED
3 - Adjust the setpoint temperature (desired temperature) using buttons
4 - Press the
button several times to set the fan speed .
Fan mode
1 - Press the
button on the control panel or on the remote control to turn on the device
2 - Press button
on the control panel or remote control several times to light up LED
3 - Press the
button several times to set the fan speed .
Dehumidification mode
In this mode, the continuous drainage pipe must be connected to drain the water into a container or to
the sewage system.
1 - Press the
button on the control panel or on the remote control to turn on the device
2 - Press button
on the control panel or remote control several times to light up LED
Fan speed and temperature adjustment are not available in Dehumidification mode.
Timer
The timer is used to start or stop the device after a time set between 0.5 h (30 min) and 24 h
• Switch on the appliance with the timer
1 - Switch on the appliance, choose the operating mode (
speed
2 - Press the
button on the control panel or on the remote control to turn off the device
3 - Press the
button
4 - Set the time until the desired switch-on time using keys
5 - After a few seconds, the setting is saved and LED
6 - When the set time has elapsed, the air conditioner will turn on with the settings.
7 - Press again
or
to cancel the Timer.
and
,
,
) and adjust the setpoint temperature and fan
and
(in number of hours).
lights up.
45
.
.
EN
Publicidad
