Kenmore 417.4191 Serie Guía De Uso Y Cuidado página 20

Care and Cleaning
Performing Manual Drain
In the event the washer will not drain under its own power
due to a power outage or clogged drain pump you can
drain the water left in the drum manually.
BURN .AZA_V
Do not attempt to manualty drain the drum if it is full of
hot water. All .... ter t .... I before p ..... ding with
m .....! dra!n!ng: .......................................................................................................................................................................
With a catch pan ready, pinch the two flaps on the sides
drain spout and flip it down.
NOTE
Removing the pump cleanout door completely may be
necessary to place your catch pan under the drain spout.
When the water has stopped flowing_ press the drain spout
back up and in until the outer flaps snap into place.
Cleaning Pump Filter
With the wash tub and drain hose drained of all water and
the drain spout snapped in place, follow these directions to
remove, clean, and reinsert the pump filter.
1. "Unscrew" the filter and pull it out.
2. Dump foreign contents from the filter tray and inspect
the opening for any loose objects.
3. Rinse the filter completely before putting it back in
place.
Check to make sure O-ring is in place before reinserting
ii
pump filter. Take care to not cross threads when turning
pump filter during reinsertiom
4. "Screw" filter back in place until it stops. The arrow on
the drain spout should be pointing upward.
5. Reinstal! pump deanout door if removed earlier.
i ii ........... ii
through th .... i ..... h detergent .... part ..... t to reprime
the drain pump.
Inspect for O-ring before
reinserting
2O