Publicidad
Idiomas disponibles
Idiomas disponibles
CHARACTERISTICS
ES
▶Power: 55W
▶Speeds: 3 levels
▶Fixed or oscillating position
PT
▶Safety grille
▶Blade diameter: 40cm
▶Manual ignition
EN
▶Maximum air flow 300m3/h
▶220-240V~ 50Hz
INSTALLATION
FR
1. Open the box and carefully remove the main body, the
grille and the fan blades. For proper storage in the future, be
sure to keep the box in good condition.
2. Remove the Fan Blades:
• Unscrew the blade from the locknut.
• The locknut will remain on the back cover.
• Remove the locknut from the back of the rear cover.
3. Install the Head:
• Turn the fan blade nut clockwise and the grill nut
counterclockwise.
• Fit the rear grille onto the motor shaft and secure it with the grille
nut.
• Fit the fan blades onto the engine shaft and secure with the fan
blade nut.
• Remove the front grille, place it next to the rear grille and then
secure it with a screw.
4. Wall mounting:
• Attach the iron plate to the wall using two nails and two plastic
screws (see picture below).
• Connect the fan body to the iron plate mounted on the wall.
Instruction manual
INSTRUCTIONS FOR USE
Before using the fan, it is important to ensure that it is installed
correctly on the wall. Follow these steps for proper operation:
1. Speed selection:
2. To set the oscillation:
3. To adjust the fan head angle: Put one hand on the fan body
and use the other hand to hold the fan head. Then gently
adjust the fan head angle to your preference.
IMPORTANT NOTES
▶Place the fan on a flat, dry surface.
▶Before connecting the device to the electricity supply, make sure
▶Plug the power cord into the mains socket 220-240V~ 50Hz.
▶If you do not use the ventilator for a long time, unplug the power
▶Never attempt to disassemble the device where the motor is located.
▶If you notice any abnormality (such as unusual noise from the fan),
▶Make sure that no objects or liquids enter the interior of the fan
Rear motor cover
Cover
Motor shaft
• Pull the line on the speed switch and choose the desired speed.
• Pull the cord 1 time: first speed - low.
• Pull the rope 2 times: second speed - medium.
• Pull the rope 3 times: third speed - high.
• Pull the rope 4 times: off - 0.
• You must pull the string 1 time to start the oscillation and the
second time will stop it at the point you are at.
that the switch is in the "0" position.
cord from the socket.
switch off the device and unplug it immediately.
Ref. 33526
Central hole
Grill nut
Internal grill part
Fan blades
Nut for securing
the blades
Publicidad
