Craftsman 900 Serie Manual Del Usuario página 17

Immediately prepare your tiller for storage
at the end of the season or if the unit wilt
not be used for 30 days or more,
,_Warning: Never store the tiller with gas-
oline in the tank inside a building where
fumes may reach an open flame or spark,
Allow the engine to cool before storing in
any enclosure.
TILLER
14 Clean entire tiller (See "CLEANING" in
the Maintenance section of this man-
ual),
2r Inspect and replace belts, if necessary
(See belt replacement instructions in
the Service and Adjustments section of
this manual).
3, Lubricate as shown in the Maintenance
section of this manual.
4. Be sure that all nuts, bolts and screws
are securely fastened. Inspect moving
parts for damage, breakage and wear,
Replace if necessary,
5. Touch up all rusted or chipped paint
surfaces; sand lightly before painting,
ENGINE
FUEL SYSTEM
IMPORTANT: It is important to prevent
gum deposits from forming in essential
fuel system parts such as the carburetor,
fuel filter, fuel hose, or tank during stor-
age, Also, alcohol blended fuels (called
gasohol or using ethanol or methanol) can
attract moisture which leads to separation
and formation of acids during storage,
Acidic gas can damage the fuel system of
an engine while in storage,
• Empty the fuel tank by starting the en-
gine and letting it run until the fuel lines
and carburetor are empty,
• Never use engine or carburetor cleaner
products in the fuel tank or permanent
damage may occur,
• Use fresh fuel next season_
NOTE: Fuel stabilizer is an acceptable
alternative in minimizing the formation of
fuel gum deposits during storage, Add
stabilizer to gasoline in fuel tank or stor-
age container, Always follow the mix ratio
found on stabilizer container_ Run engine
at least 10 minutes after adding stabilizer
to allow the stabilizer to reach the carbu-
retor. Do not empty the gas tank and
carburetor if using fuel stabilizer.
ENGINE OIL
Drain oil (with engine warm) and replace
with clean oil, (See "ENGINE" in the
Maintenance section of this manual)°
CYLINDER
1, Remove spark plug,
2, Pour 1 ounce (29 ml) of oil through
spark plug hole into cylinder.
3. Pull starter handle slowly several times
to distribute oil,
4. Replace with new spark plug,
OTHER
• Do not store gasoline from one season
to another_
• Replace your gasoline can if your can
starts to rust, Rust and/or dirt in your
gasoline will cause problems.
• If possible, store your unit indoors and
cover it to give protection from dust and
dirt,
• Cover your unit with a suitable protec-
tive cover that does not retain moisture.
Do not use plastic, Plastic cannot
breathe which allows condensation to
form and wilt cause your unit to rusL
IMPORTANT: Never cover tiller while en-
gine and exhaust areas are still warm,
17