GE 22 Manual Del Propietario E Instalación página 20

Installation Instructions
REVERSING THE DOOR SWING
(CONT.)
[] TRANSFER CENTER HINGE
BRACKET TO THE LEFT
]_.emove tile (enter hinge bracket by removing
tile three screws,
NOTE: Keep these screws with tile hinge bracket.
They are long screws and will be used when installing
tile hinge on tile other side.
Y_u will need to i'eillove tile colo>matched cap fl'om
tile screw head
befk)i'e VOtl
C}IIII'eIllOVe tile screw.
Use tile edge of a thin fiat blade to gently P_Y tile
caps off tile screw heads. (A putt)' knile works well
tot this,) Cover tile blade with tape to prevent
scratching tile paint,
Remove tile mullion cover fl'om tile lefi side using
the thin fiat blade. Assemble it to the right side.
Remove the screw flx)m the center leli side of the
cabinet. Screw it into the holes on the right side.
Place the center hinge bracket over the holes at
the center leli side of the cabinet. Insert and
tighten the three hmg screws.
Replace tile cap by
snapping
it over tile screw with
yore" finger.
[] TRANSFER DOOR STOPS
On each doo_, mo_e tile metal door stop fl'om tile
right to tile left.
Moxe any screws fl'om tile left to tile right.
[] TRANSFER REFRIGERATOR
DOOR HANDLE TO THE RIGHT
To remove the handle: Remove tile plug button by
careflflly pr)_ng trader tile edge with a putt)' knife.
Remove tile exposed screw holding tile handle.
t
Handle Plug
Remoxe tile two screws holding tile handle to tile
top of the door,
Long Handle Short Handle
Short
Screw
Hole Handle
N Plug
Pin
Handle
After removing the handle: Move tile small plug
buttons fl'om tile top fight side of tile door top and
insert them into tile holes on tile opposite side.
Small P h,
Buttons
Move tile large, I)lu°,_button fl'om tile left edge of the
door and insert it into the hole on the opposite side.
PlugButton
I
2O