10. Additional safety instructions
• The appliance is water-resistant, NOT waterproof. The appli-
ance must be installed above ground and perpendicular to the
water tap. Do not immerse the appliance in water!
• DO NOT pull on the hose while it is connected to the irrigation
controller to prevent damage to the timer
• This device is only intended for outdoor use to control irriga-
tion systems.
• The device must not be used for industrial purposes
• The operating water pressure is between 0.5 bar and 8 bar (7
psi to 116 psi).
Only use with clean water and fresh water, the water tempera-
ture must be above 1°C and below 60°C.
• Protect the appliance during the winter season or in the event
of frost. Remove the appliance from the tap and drain all the
water from it. Remove the batteries and store the appliance
and batteries indoors.
• Do not use the appliance if it has been dropped or knocked.
• Make sure that you clean the filter regularly if it is dirty.
11. Cleaning
After a certain period of use, impurities or dirt can accumulate
in the appliance. The appliance should therefore be cleaned
regularly to ensure proper operation. Please follow the steps
below to clean the timer.
1.
Turn off the garden tap and dismantle the appliance.
Check whether impurities have accumulated in the filter
on the water inlet.
2.
If the filter is dirty, remove it and rinse it under running
water.
36
English