GET SX1 LC-GPA Guia página 9

GPA SETTING MODE
GPA Display Mode GPA Setting Mode NEW GPA Level set
5
6
4 7
3 8
2 9
LC LC LC
1 10
HOLD RELEASE
MFL MFL MFL
2 sec 2,5 sec
To switch from "GPA Display" mode to "GPA Setting" mode, press the GPA
activation button on the SX1 CONTROLLER for about 2 seconds. Release the button.
The blue LEDs on the SX1 LC-GPA indicating the current set GPA level and the red MFL
light will start flashing.
NOTE: If the current GPA level is 0, only the red MFL light will start flashing.
By pressing the Map 1 and Map 2 selection buttons on the SX1 CONTROLLER, you can
increase or decrease the GPA assistance level until the desired value.
The blue LEDs on the SX1 LC-GPA will progressively turn on or off based on the button
pressed (Map 1 or Map 2).
Once the desired level is reached, release the button. After 2.5 seconds, the LEDs on the
SX1 LC-GPA will stop flashing, indicating that the new GPA level is set. The device will
automatically switch back to "Visualizzazione GPA" mode.
NOTE: - It is possible to activate and complete the "GPA setting mode" only with engine
running below 8000 RPM and with throttle position below 10%.
- If a specific GPA level is set directly on the power maps of GET ECU, this level will not be
followed when installing SX1 LC-GPA. In this case the GPA level the maps will follow is
the one selected with the SX1 LC-GPA.
EN
9