Publicidad
Idiomas disponibles
Idiomas disponibles
HEADLAMP INSTRUCTIONS
The headlamp has three modes: Bright light, dim light, and
strobe light. The unit uses 3 AAA batteries (included) and
can be replaced by opening headlamp housing.
1. To power on unit, depress power button. Bright light is
on by default.
2. To switch light mode, depress button again until desired
mode is reached.
3. To power unit off, depress button until unit powers off.
HOW TO USE YOUR BOOSTER CABLES
Determine which battery post is connected (grounded) to the vehicle chassis on the
vehicle with the discharged battery. If the negative post of the discharged battery is
grounded, connect the booster cables as outlined in the diagram below and follow below
instructions or instructions attached to cables.
1. Face both vehicles head to head if possible in order for booster cables to reach each
vehicle's battery.
2. Properly follow the connection in the order listed:
A Positive (+) cable should be connected to the positive (+) terminal of the discharged
battery.
B Connect the other end of the positive (+) cable to the positive (+) terminal of the
good battery.
C Connect the negative (-) cable to the negative (-) terminal of the good battery.
D Make final connection of the other end of the negative (-) cable to the engine block
or other unpainted metal area of the vehicle with the discharged battery (not to the
negative (-) post).
3. Start vehicle with discharged battery. Once vehicle is started, remove cables in reverse
order of above, starting with disconnecting the negative (-) engine block connection
first.
DEAD BATTERY
D
ENGINE
BLOCK
NEGATIVE
TERMINALS
A
POSITIVE
TERMINALS
DONOR BATTERY
C
B
Publicidad
