Sangean Vocal 170 Instrucciones De Manejo página 6

4.
Or press the Seek button to seek for the next available station. To seek up in frequency, rotate the Tuning knob in a
clockwise direction, then press the Seek button. Your radio will seek in an upwards direction (low frequency to high
frequency) and stop automatically when it finds a station of sufficient strength.
To seek down in frequency, rotate the Tuning knob in a counter clockwise direction, then press the Seek button. Your
radio will seek in a downwards direction and stop automatically when it finds a station of sufficient strength.
5.
Rotate the Volume knob to get required sound level.
6.
To turn off the radio, press the Power button.
Storing station presets – FM / AM
There are 5 presets each for FM and AM radio. They are used the same way for each operating mode.
1.
With your radio switched on, press the Band button to select the desired frequency band.
2.
Tune to the desired radio station as previously described.
3.
Press and hold the desired preset button for more than 2 seconds. The preset number will appear in the display
(such as: ). The station will be stored under the chosen preset button.
4.
Repeat this procedure for the remaining presets.
5.
Stations stored in preset memories can be overwritten by following the above procedures.
Recalling stations presets – FM / AM
1.
With your radio switched on, press the Band button to select the desired frequency band.
2.
Momentarily press the desired Preset button, the preset number and station frequency will appear in the display.
RDS function
This function only applies when an FM station provides the RDS service.
When an FM station provides RDS service,
and then show the radio text if radio text is provided.
RDS CT (Clock Time) Set
Select an FM radio station which provides RDS CT service, press and hold CT (Clock Time) button for more than 2
seconds, the display will flash
When it shows "No CT" this means there is no CT (Clock Time) service.
To view the time and frequency, press the Display button.
NOTE
Not all stations broadcast the CT (Clock Time) and may not always be accurate. This is the fault of the radio stations
signal not your radio.
AUX IN
1.
Turn on the radio, and press the BAND button until "AUX IN" is displayed.
2.
Connect a stereo or mono audio source using a standard 3.5mm connector (e.g. iPod, MP3 or CD player) to the
Aux in socket on the left side of the radio.
3.
Adjust the Volume control on your iPod, MP3 or CD player and your radio.
shows on the display and the display will show the station name
. The clock time will be aligned automatically once the CT service is available.
GB
F
E
NL
D
05