HTM HTW-VP-50FD Manual De Usuario página 9

Pedestal fan HTW-VP-50FD USER MANUAL
2 ASSEMBLE THE STAND ONTO THE FAN BEFORE USE
Fig.1: Leg pipe and tripod connection.
• Rotate the three leg pipe (3) counterclockwise into the tripod respectively (2)
Fig.2: Attaching the motor housing (4) to the top of the column pipe (1)
• First remove the pivot knob (2) and the bolt (6) from the top of the telescopic stand, then remove the neck
retaining screw (3) and small adjustment knob (5) from the motor housing bracket.
• Place the motor housing on the top of the stand and thread the large pivot bolt (6) through the bracket.
Screw in the small retaining screw (3) and tighten, but do not overtighten.
• Fit the large pivot knob (2) onto the end of the bolt (6) and the small adjustment knob (5) at the other side
above the bolt. Tighten the knobs while holding the fan motor upright.
INSTRUCTIONS
The fan is equipped with 3 speeds and an oscillation option. To use the fan, follow the simple instructions
below.
Place the fan on a dry, level surface where it will not overturn during use.
Make sure the speed control on top of the motor housing is in the OFF [ 0 ] position, then insert the power
plug into an appropriate electrical outlet.
SPEED SELECTION
Select the fan speed. Simply move the speed control from the OFF [ 0 ]
position to the desired setting.
0 OFF
I LOW
II MEDIUM
III HIGH
9
