Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
1-21STORIVIWINDOW
REQUIREMENTS
A storm window
frame will not allow the air
conditioner
to tilt towards
the outside
and will
keep it from draining
properly.
To adjust for this,
attach a piece of wood
to the stool.
1/2"higher
_
,_./Wood
than
A
frame
Storm"
I]
II
window
/I
II
frame
/_
II
WOOD PIECES:
WIDTH:
2"
LENGTH: Long enough to fit inside the window
frame.
THICKNESS:
To determine
the thickness,
place a
piece of wood
on the stool to make it 1/2" higher
than the top of the storm
window
frame.
Attach
securely
with
nails or screws provided
by
the installer.
r_REMOVE AIR CONDITIONER FROM CASE
[]
Remove
the front grille.
See the Care and
Cleaning
section,
[]
Find the locking
plate located on the front
left side,
[]
Remove
the screw and the locking
plate to
Locking
plate
screw
unlock the air conditioner.
[]
[]
Remove
and discard the shipping
screw
on the back of the air conditioner
to allow
removal
of the air conditioner
from the
case.
Pull the bottom
corners
of the air
conditioner
and slide it out of the case.
[]
Remove
the three shipping
pads inside the air
conditioner
next to the compressor.
Remove
shipping
pads
[]
Remove
the rear grille that is taped to the back
of the case. Remove
the packet of screws taped
to the back of the grille. While
holding
the grille
at a 45 ° angle, insert it into the clips at the top of
the case and push the bottom
in. Keep slight
upward
pressure
on the grille until it fits flush
with the bottom
of the case.
If attaching
the grille
from the outside
of
the case use the 2
long screws.
If attaching
the grille
on the inside of the
case use the 2 short
screws.
Clips
Insert the 2 long screws
on
the outside
I
/lllllllllllllllllllllllllllllllllllllllllll
I,
/lllllllllllllllllllllllllllllllllllllllllll
/I
/lllllllllllllllllllllllllllllllllllllllllll
H
Insert
the 2 short
screws
on the inside
17
Publicidad
