Perel CH0001 Manual Del Usuario página 6

6. Installation
Install the feet on the bottom of the appliance. Fix each foot with two screws.
Install vertically on a flat, dry, stable and non-slippery surface.
7. Operation
7.1 General Operation
Insert the power plug into the mains.
Turn the thermostat knob fully to the right.
Switch on the heater by selecting the power (
When the room has reached the desired temperature, turn the thermostat knob to the left until
the heater switches off. The temperature is now set and the heater will automatically switch
on/off to keep the temperature at a constant level.
Switch off and disconnect the heater after use.
7.2 Setting the Heating Time
This heater features a timer that you can use to set the desired heating time. Once the timer
expired, the heater switches off automatically.
1. Turn the timer disc so that the pointer indicates the start time where you want to switch on
the heater.
2. Set the slide switch at the central position.
3. Now, push the corresponding segments to set the desired time span. Each segment
represents 15 minutes. The heater will only function at the set time.
4. Set the slide switch to I if you want the heater to run continuously; set the slide switch to 0
to switch off the timer.
7.3 Overheating Protection
This heater is equipped with an overheating protection, which will automatically switch off the
heater in case of overheating. If this occurs, please unplug from the mains and allow cooling
for 30 minutes before re-connecting and switching on again.
To avoid overheating, check that the appliance is sufficiently ventilated and that the air intakes
are unobstructed. Please contact your local dealer if the heater keeps switching off.
V. 02 – 15/06/2018
CH0001
= fan only/750 W/1250 W/750 W + 1250 W).
6 ©Velleman nv