PURLINE VENTY AEOLIUS Manual De Instrucciones página 13

ASSEMBLY INSTRUCTIONS
The only tool needed for this assembly procedure is a screw driver.
y Screw the fixing plate out of the stand tube in anti-clockwise direction. Put the stand tube
onto the base. Screw the fixing plate firmly by fixing screw from the bottom of the base in
clockwise direction so that combine the stand tube and base well.
y Pull the extension tube out to desired height then tighten the height adjustment knob.
y Put motor unit on top of extension tube, tighten screw B.
y Unscrew the grille lock which are fixed on the motor front cover. Put the rear grille on the
motor front cover, tighten it with the lock.
y Slide blade on motor shaft, then screw blade cap on shaft by turning counter clockwise.
y Put front grille on rear grille and unite both grilles by plastic ring, tighten the screw and nut
attached.
OPERATION
y Place your fan on a level and dry surface.
y Plug the power cord into a standard 220-240VAC outlet. Please make sure the Selector (Speed
Control) is in the OFF position. Select the desired speed setting. There are 4 settings – 0 (off ),
1 (low), 2 (medium) and 3 (high).
y The fan can be set to oscillate by pushing Oscillating Knob downwards. To stop the oscillating
feature, pull-up the Oscillation Knob.
y To adjust the tilt angle of fan head upward or downward by simply moving the guard up or down.
y Remove plug from the power outlet after use.
EN
13