Publicidad
Idiomas disponibles
Idiomas disponibles
Input and audio controls
ventilation
1. INPUT:
Input of the signal to be amplified. Connect to the radio/player
through high quality shielded RCA cables to prevent unwanted noise.
2. LEVEL:
This control allows the adjustment of the signal level at the input
of the amplifier that will be sent to the audio output.
3. BASS BOOST:
the frequency of 45Hz by up to +20dB.
4. COOLER:
It provides cooling of the amplifier. Install in a cool place without
obstruction of air inlets and outlets.
5. PRE-EQUALIZATION SWITCH
BASS EQ:
In this position, the amplifier will have a tone aimed at playing
speakers of the type WOOFER and SUB WOOFER.
FLAT:
In this position, the amplifier has a flat response, maintaining the
original audio timbre.
MID EQ:
In this position, the amplifier will have a timbre aimed at playing
MIDDLE type speakers.
The BASS EQ and MID EQ channels, as well as the FLAT channel do not have Low
Pass or High Pass filters, so it is necessary to use a audio processor to perform
the cuts according to the configuration of your sound.
1
This control allows the reinforcement of bass, enhancing
2
3
4 4
5
12
ventilation
Publicidad
