Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION OF SPEAKERS
This amplifier has a two-channel audio output, which allows the installation
of speakers in stereo and bridge mode by joining both channels for the use
of WOOFER and SUBWOOFER. It is possible to use stereo and bridge mode
together (tri-mode) as in the figure below:
Installation STEREO + BRIDGE (Tri-Mode)
Speakers in
BRIDGE mode:
Minimum impedance
of 2 OHMS
Speakers:
10 AWG cables
STEREO mode
speakers:
Minimum impedance
of 1 OHM
Troubleshooting
AMPLIFIER DOES NOT TURN ON:
▪ Verify that the cables are connected correctly. Make sure all connections
have electrical and mechanical contact.
▪ Fuses or circuit breakers may be defective or blown. Check the condition of
the circuit breakers and if it is compatible with the equipment consumption.
▪ Verify that the battery charge is sufficient for the operation of the product.
NO SOUND:
▪ The cables of the speakers or RCA plugs may not be connected correctly
or are defective.
▪ Verify that the LEVEL control is not at a minimum.
Check the minimum impedance
supported by the amplifier.
16
Publicidad
