Publicidad
Idiomas disponibles
Idiomas disponibles
9 FEATURES
Your eccentric sander is equipped with TPR soft grip and protective parts. TPR (Thermoplastic
rubber) is elastic, chock absorbing and environmental friendly (recyclable).
10 ASSEMBLY
10.1
Installing or removing the abrasive belt (Fig. 4)
▪
Pull the adjustable belt knob (4) to the forward position.
▪
Put the belt on the driving wheel and pull the belt to the front of the arm, and then make
the belt slip over the belt wheel.
▪
Return the adjustable belt knob (4) to the original position.
10.2
Adjusting belt tracking (Fig. 5)
▪
Check if the sanding belt is running centrally before starting the work.
▪
Run the file at freely and turn the adjustable track knob either clockwise or anti-clockwise
to adjust the belt tracking until the sanding belt is running smooth.
11 OPERATING INSTRUCTIONS
Before attempting to use your sander be sure to familiarize yourself with all its operating
features and safety requirements.
Warning! The battery should always be removed from the machine when
assembling parts, marking adjustments, cleaning or when the tool is not in
use. Disconnecting the battery will prevent accidental starting that could
cause serious injury.
Do not sand plaster surfaces, (WARNING: In this case your guarantee
becomes void) this may clog the motor (brushes, ball bearings, ...).
11.1
Sanding operation (Fig. 6)
▪
Hold the tool with both hands in front of you and away from you, and assume a balanced
posture.
▪
Turn on the tool and allow the motor to reach full speed.
▪
Gently apply the tool to the workpiece surface and move the tool forward and back.
▪
Press the belt only lightly on the workpiece. Excessive pressure may damage the belt
and shorten tool life.
11.2
Switching On-off (Fig. 7)
Connect the battery pack (7) to the power tool by pushing the release button (8).
The tool is operated by pressing/releasing the trigger switch (3). The machine will start by
pressing the trigger switch (3) and stop when releasing the trigger switch (3).
Press the lock-on button (2) and the trigger switch at the same time to lock the switch into
position and the machine will work continuously.
Press the trigger switch all the way to the end and then release it to unlock the tool again.
11.3
Changing the speed (Fig. 8)
▪
The rated speed and impact rate can be adjusted just by turning the speed adjusting dial
(6). Adjusting the variable speed selector (6) from 1 to 6 will accelerate.
▪
Adjusting the variable speed selector (6) from 6 to 1 will slow down.
▪
Please choose the right speed according to the work piece.
Copyright © 2022 VARO
POWDP50700
P a g e
| 8
EN
www.varo.com
Publicidad
