Bosch Purion 200 Instrucciones De Montaje página 5

General Information
Pictograms used
Tools required for the work step
Actions displaying this pictogram must be per-
Nm
formed with a torque spanner and the screw must
be tightened to the specified torque, otherwise
there is a risk that the components will be dam-
aged.
Required Tools and Materials
– 3 mm hex key
– 0.5 Nm torque wrench
Note: Do not use a ball end hex key on flat head hex screws.
Indicated Components
(1)
(3)
(1) Operating unit
(2) Connection cable
(3) Clamping screw
Bosch eBike Systems
Installing the Operating Unit
(4)
(3)
Loosen the clamping screw (3) of the operating
unit Purion 200 (1) and open the clamp (4).
(5)
(2)
(1)
Loosen the clamping screw of the brake lever (5) and push
the brake lever away from the handlebar grip such that the
operating unit Purion 200 (1) can be installed.
Place the operating unit (1) on the handlebars between the
handlebar grip and the brake lever (5) and screw in the
clamping screw (3) slightly.
It recommended to align the operating unit (1) so that the
plus/minus button level is almost perpendicular to the floor.
This means that the operating unit is ergonomic to operate
and easy to read.
The operating unit (1) has a recess for the brake lever (5) on
the underside. Align the brake lever and the operating unit
with each other accordingly.
Align the brake lever (5) such that it is ergonomic to operate.
To do this, refer to the information provided by the brake
manufacturer.
Note: Ensure that the operating unit (1) and the brake
lever (5) do not come into contact.
English – 1
(1)
(3)
M 275 007 3RP | (16.04.2023)