Faber hoods IN-NOVA PREMIUM Manual De Uso página 6

4. CONTROLS
Button Function
Turns the lights on/o昀昀 at maximum strength.
L
Turns the motor on/o昀昀 at speed one.
T1
Keeping the button pressed for approximately 2 seconds starts/stops the temperature
sensor.
T2 Turns the Motor on at speed two.
Press and hold the button for approximately 5 seconds, with all the loads
turned o昀昀 (Motor and Lights), to turn the Activated Charcoal Filter alarm on. The
relevant LED 昀氀ashes twice to con昀椀rm.
To turn the alarm o昀昀, press the button again and hold for at least 5 seconds.
The relevant LED 昀氀ashes once.
T3 Turns the Motor on at speed three.
Press and hold the button for approximately 3 seconds, with all the loads turned
o昀昀 (Motor and Lights), to perform a reset. The LED S1 昀氀ashes three times.
T4 Turns the Motor on at INTENSIVE Speed.
This speed is timed to run for 6 minutes. At the end of this time, the system
returns automatically to the speed that was set before. If it is activated with the
motor turned o昀昀, the hood will switch to OFF at the end of the time.
Press and hold for 5 seconds to enable the remote control, indicated by the
LED 昀氀ashing twice.
Press and hold for 5 seconds to disable the remote control, indicated by the
LED 昀氀ashing just once.
S1 Signals the Metal Grease Filter saturation alarm, indicating that it is necessary
to wash the 昀椀lters. The alarm is triggered after the Hood has been in operation
for 100 working hours.
When this is activated, it signals the Activated Charcoal Filter saturation alarm,
indicating that the 昀椀lter must be changed; the Metal Grease Filters must also
be washed. The Activated Charcoal Filter saturation alarm comes into operation
after the Hood has been working for 200 hours.
WARNING: the temperature sensor is active when the hood is started. If, when the hood is o昀昀, the tempe-
rature detected by the sensor exceeds the set limit, the hood will turn on at speed two. When the tempe-
rature detected by the sensor returns below the threshold value the hood will turn o昀昀. In the event of the
temperature not returning below the threshold value for approximately 90 minutes, the hood will turn o昀昀 (the
sensor is disabled for approximately 15 minutes, after which it will return to the previous setting). If the hood
is adjusted manually (switching on/changing speed) the sensor is disabled and the hood must be turned o昀昀.
After turning the hood o昀昀, the sensor is disabled for approximately 15 minutes, after which it will return to
the previous setting. The temperature sensor does not guarantee automatic start-up of the hood, as its
operation is in昀氀uenced by environmental conditions, types of cooking operation, height and installation of
the hood (tested at 530 mm).
WARNING: the sensor does not work with induction cookers.
6
Led
-
Fixed.
1 昀氀ash of LEDs T2
and T3 algorithm
activated.
2 昀氀ashes of LEDs
T2 and T3 algorithm
deactivated.
Fixed.
Fixed.
Fixed.
Fixed.
Flashing.