J
ASSEMBLY INSTRUCTIONS
1a. Find Back panel (3) and Bottom panel (4).
1b. Match up "A" label on Back panel (3) with "A" label on Bottom panel (4)
and click together. Make sure the connection is flush across the entire
joint and there are no gaps between the two panels.
*
Assembly Tip – Make sure edges are aligned before clicking
together.
** Assembly Tip – To attach side panels you may find it easier to
flip the cabinet on its side(s). Be careful not to damage or scratch
the finished sides.
2a. Find Left panel (1) and Right panel (2).
2b. Match up "B" label on Left panel (1) with "B" label on Back panel (3)
and click together. Make sure there are no gaps between the three
panels.
2c. Match up "C" label on Right panel (2) with "C" label on Back panel (3)
and click together. Make sure there are no gaps between the three
panels.
3a. Find Top left rail (5) and Top right rail (6).
3b. Match up "D" label on Top left rail (5) with "D" label on Left panel (1)
and click together. Make sure there are no gaps between the three
panels.
3c. Match up "E" label on Top right rail (6) with "E" label on Right panel
(2) and click together. Make sure there are no gaps between the three
panels.
1
A
A
Align
2
Click
4
2
3
C
Click
C
3
4
2
E
E
6
3
Click
4
ASSEMBLY INSTRUCTIONS
4a. Find Front frame(7).
4b. Match up "F" label on Front frame(7) with "F" label on Bottom panel
(4) and click together. Make sure there are no gaps on all four connec-
tion sides.
Click
4
3
5. Attach the Feet (19) to the Bottom panel (4) use a rubber mallet.
Then lift the legs in the direction of the arrow, press to secure, rotate to
adjust to the desired height.
Hardware Used
1
19
Foot
B
B
6. Attach the Slide support (18) to the Back panel (3), using M4x15 mm
Screws (16);
Then attach the Drawer Slides (17) and insert it into the mount, lock the
Drawer Slides (17) to Front frame (7) with using M4x15 mm Screws
1
(16).
Hardware Used
D
D
16
M4x15mm Screw
5
17
Drawer Slides
18
Slide support
Click
4
F
7
F
Click
4
2
5
19
1
x 4
6
16
18
x 16
3
1
x 2
x 4
5
Click
1
16
17