5. Trouble shooting
In the event that you detect a problem, we suggest that you check the following
list before requesting technical service.
Symptom
Possible cause
No power
1. Power supply not connected.
2. Bad contact between the power
plug and the receptacle.
3. The power of the receptacle is
off.
No sound
1. Incorrect signal connection.
2. The disc is deformed or get dirty.
3. The system is in hte mute status.
No picture
1. Incorrect signal connection.
2. Incorrect TV status.
No color
1. Wrong selection of TV
system.
2. Improper color adjustment.
3. Incorrect video output set-
tings.
Disc cannot be pla-
1. No disc in the drive.
yed
2. Disc place wrongly.
3. Moisture has condensed in
the unit.
4. Not in a playing status.
5. Wrong disk format.
6. Disk is dirty.
Remote controller
Remedy
malfunction
1. Connect to the power
supply.
2. Plug again or replace a re-
ceptacle.
3. Switch on the receptacle.
1. Connect the signals properly.
2. Clean or fix the disc.
Sudden malfunction
3. Press the "MUTE" button
again.
1. Connect the signals pro-
perly.
2. Adjust the TV/AV status.
1. Setup the system by pres-
sing the "System" button
of the Remote Controller.
Picture dividing
2. Readjust the color
3. Check if the video output
settings are correct.
Disposal of old appliance.
According to the European standard 2002/96/EC on waste electrical and electronic equip-
1. Insert a disk.
ment (WEEE), the old appliance can not be placed in the municipal standard, must be co-
2. Put the disk on the disk tray
llected separately in order to optimize the recovery and recycling of components and
properly with the label side
up.
materials they contain, and reduce the impact on human health and the environment. The
3. Leave the unit on for about an
symbol of the trash bin with a cross on top is placed on all products to remind consumers
hour (without disk) and before
of the obligation to separate them for collection.
using it again.
4. Press the "Play" button to switch
Consumers should contact the local authority or retailer for information concerning the
to playing status.
disposal of your old appliance.
5. Repalce it with a supported
disk.
6. Clean the disk with a soft cloth
from the centre to the edge.
8
Symptom
Possible cause
1. The remote controller is not
directed at the sensor.
2. The receiving distance is
more than 8 meters.
3. Low voltage of the RC batte-
ries.
4. There is an obstacle bet-
ween the unit and the RC.
1. Bad disc quality.
2. Press other button by mis-
take.
3. Static from the outside.
1. The selected system is in-
compatible with the disc.
Remedy
1. Direct the remote contro-
ller at the sensor.
2. Reduce the receiving dis-
tance.
3. Replace all the batteries.
4. Remove the obstacles.
1. Wait for 5-10 seconds and
the playing will be resto-
red.
2. Operate again.
3. Shut off the unit for 1-2
minutes and open it again.
1. Set up the correct system.