DeWalt D28885 Manual De Instrucciones página 20

17 Do not abuse cord
Never carry the tool by its cord. Never pull the
cord to disconnect from the socket. Keep the
cord away from heat, oil and sharp edges.
18 Store idle tools
When not in use, tools must be stored in a dry
place and locked up securely, out of reach of
children.
19 Maintain tools with care
Keep the tools in good condition and clean for
better and safer performance. Follow the
instructions for maintenance and changing
accessories. Keep all handles and switches dry,
clean and free from oil and grease.
20 Repairs
This tool is in accordance with the relevant safety
regulations. Have your tool repaired by an
authorised D WALT repair agent. Repairs should
E
only be carried out by qualified persons using
original spare parts; otherwise this may result in
considerable danger to the user.
Additional safety rules for grinders
• Your grinder has been designed for grinding and
cutting masonry and steel.
Do not cut or grind light metal with a
magnesium content exceeding 80%
since this type of metal is flammable.
• The max. allowable speed of the grinding wheel
or cutting accessory, or any other suitable
accessory, must always be equal to or greater
than the no-load speed of the tool specified on
the nameplate.
• Do not cut workpieces requiring a maximum depth
of cut exceeding that of the cutting accessory.
• Always use accessories with a shank diameter
corresponding to the size of the collet installed in
your tool.
• Do not use grinding and cutting accessories that
do not conform to the dimensions stated in the
technical data.
• Inspect grinding and cutting accessories before
each use. Do not use chipped, cracked or
otherwise defective accessories.
• Ensure that the grinding or cutting accessory is
mounted correctly before use.
• Let the tool run at no-load in a safe position for at
least 30 seconds.
If there is a considerable vibration or if any other
defect occurs, stop the tool and check it to
determine the cause.
• Check that the workpiece is properly supported.
• Do not operate this tool without the switch guard
in place.
• Do not operate the tool near flammable liquids,
gases or dust. Sparks or hot chips from cutting
or arcing motor brushes may ignite combustible
materials.
• Do not operate the tool while standing in line with
the accessory. Keep other persons away from
the work area.
• Do not use cutting discs for side grinding.
• Do not operate the spindle lock while the tool is
running.
• Beware that after switching off the tool the wheel
continues to rotate for a short period.
• Always store grinding and cutting accessories in
a dry place.
Package contents
The package contains:
1 Straight grinder
1 Spanner (13 mm) (D28885)
1 Spanner (19 mm)
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fig. A)
Your straight grinder D28885/D28886 has been
developed for professional grinding and cutting
applications.
1 On/off switch
2 Switch guard
3 Spindle lock (D28886)
4 Collet nut
5 Speed control dial (D28886)
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
E N G L I S H
19