jcm-tech 230START Manual Del Usuario página 3

Mechanical installation
Connect the wired output (230START only).
It is recommended to program the receiver before installing (especially if the final location has difficult access).
Manual programming
Press the receiver programming button for 1 second and an acoustic signal will be heard and the led will turn on. The receiver
will enter programming. Press the transmitter to be programmed. Every time a transmitter is programmed, the receiver will
issue an acoustic signal for 0.5 sec. After 10 seconds without programming or pressing the first two transmitter buttons, the
receiver will exit programming mode, issuing two acoustic signals of 1 sec. If upon programming a transmitter the receiver
memory is full, it will issue 7 acoustic signals of 0.5 seconds and exit programming.
Total reset
While in programming mode, keep pressed the programming button and press the reset button too with a paper clip (or sim-
ilar). The receiver will issue 10 short acoustic warning signals followed by others at a faster pace to indicate that the operation
has been successful. The receiver is now in programming mode.
After 10 seconds without programming or quickly pressing the programming button, the receiver will exit programming mode,
issuing two acoustic signals of 1 sec.
Operating
The led are activated every 5 seconds to indicate the correct supply of power to the equipment.
230START:
Upon receiving a code, the receiver checks whether it is in its memory, activating the wired output in an impulsional way. The
230V output plug is always on.
230SOCKET:
Upon receiving a code, the receiver checks whether it is in its memory, activating the 230V output plug in a biestable way.
jcmtechnologies
3