Publicidad
Idiomas disponibles
Idiomas disponibles
DESCRIPTION OF THE HOOD
2
1
1.
Blower and light controls
2.
LED lamps
CONTROL
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the
hood before cooking and allow it to operate several minutes
after the cooking is complete to clear all smoke and odors
from the kitchen.
The hood controls are located on the center side of the range
hood.
Recessing Knobs
•
You can hide control knobs by depressing them until flush
with the hood body.
•
Pressing the knobs again will lower the knobs, and enable
the user to operate the lights and blower.
Controls
A
A. Lamps knob
B. Blower knob
10
4
3
3.
Grease filter handle
4.
Grease filter
B
Operating the lamps
1.
Turn the light switch to the "ON" position to turn the
range hood lights On.
2. Turn the light switch to the "OFF" position to turn the
range hood lights Off.
Operating the blower
1.
Turn the blower switch at "1" to turn the range hood on.
2. Turn the blower switch to the desired speed position.
3. Turn the blower switch to the "MAX" position to turn the
range hood on High.
4. Turn the blower switch to the "OFF" position to turn the
range hood blower Off.
Auto On blower
The range hood is equipped with a sensor to automatically
turn on the blower when excessive heat is detected in the
control area. When the blower switch is in the "Off" position,
this sensor will turn the blower to high speed when necessary.
When the heat decreases, the blower will turn off. When the
blower switch is in the On position, the heat sensor is not
active and the range hood functions normally.
CFM Reduction
Single motor: When the CFM harness reduction is connected,
"Boost", "High" & "Med" will perform with "Med" settings.
Double motor: When the CFM harness reduction is connect-
ed, "Boost", " High", "Med" & "Low" will perform with "Low"
settings.
MAINTENANCE
Cleaning
Exterior surfaces:
To avoid damage to the exterior surface, do not use steel wool
or soap-filled scouring pads. Rub in direction of the grain line
to avoid scratching the surface.
Always wipe dry to avoid water marks.
•
Stainless Steel Cleaner and Polish.
•
Mild liquid detergent and water.
•
Wipe with damp soft cloth or non abrasive sponge, then
rinse with clean water and wipe dry.
•
Do not use chlorine base cleaners.
Metal Filters and Drip Trays (models PINAR and PINSV):
1 Use 2 hands to remove filters.
2 Grasp the filter handles, pull toward the front of the hood and
pull up on the rear handle.
1
2
A. Front handle
B. Rear handle
A
B
Publicidad
