Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
PLAN HOW YOU WILL INSTALL THE
SOFTENER
You must first decide how to run in and out pipes
to the softener. Look at the house main water pipe
at the point where you will connect the softener.
Is the pipe soldered copper, glued plastic or
threaded
galvanized? What is the pipe size?
-AWARNING:
Use only lead-free solder and
flux to prevent lead poisoning.
See Typical Installation
Illustration.
Use this as a guide
when planning your particular
installation.
Be sure
to direct the incoming
hard water supply to the
softener
valve inlet fitting.
The valve is marked
IN and OUT.
TYPICAL INSTALLATION
ILLUSTRATION
Soft
ate
_
' 'ATER pip
I lll LI
--_-
water
24V
120-volt
I lii
k__.___
Hard
transformer
outlet
Jill
--_--_-:_water
to
|
,/
_.
1" female
outside
V _I"
_
adapter (2) faucets
jill!j
_
(not supplied)
_-_J
_
_-_ 1" NPT male
adapter (2)
O-rings (2)
Salt hole
3s (2)
cover
INLET
"O-rings
(2)
NOTE: See Drain
Hose Connections
section.
Fig. 1
CROSSOVER
Use if water supply flows
from the left. Include single
or 3-valve bypass.
water
From
softener
t
outlet
Soft
water
To softener
inlet
OPTIONAL 3-VALVE BYPASS
INSTALLATION
ILLUSTRATION
HERE
Brinewell
Fig. 2
CROSSOVER
Use if water supply flows
from the left. Include single
or 3-valve bypass.
Hard
water
Soft
water
From
I TO softener
softener
outlet
* inlet
3-Valve Bypass
System
For soft water
service:
• Open the inlet
and outlet
valves
• Close the
bypass valve
For bypass hard
water:
• Close the inlet
and outlet
valves
• Open the
bypass valve
Publicidad
