Remove the water tank and fill with water.
Install the water tank in the machine.
On/Off general button.
A.
B.
Pre-heating of equipment.
A.
B.
Ready for use.
LONG PERIOD OF NON-USE
• Remove it and open the cover and fill with 1 L of water.
• Once the water tank has been filled replace it in the correct position and check if it is
properly installed.
• Connect the electrical plug to the respective earthed socket.
• Switch the On/Off general button which is located at the back of the equipment.
The buttons on the control panel will blink in sequence (green colour) when the
equipment starts to pre-heat (approximately 60").
• As soon as the buttons on the control panel stop blinking in sequence (green colour),
the pre-heating is over.
• Put a cup (with capacity exceeding 180cc) on the cup tray under the extraction nozzle.
Press the long drinks extraction button/water button/purge to rinse the machine, repeat
three times.
C.
C.
QOOL
53