m
Please remove the spark plug cable to
prevent accidental
ignition of the engine
before making
any repair.
Engine Will not start.
= No gasoline.
Fill gas tank.
• Low oil level sensor activated.
- Add oil.
Choke is not in correct
position.
- Slide choke lever out to closed
position.
Engine throttle
is not in correct
position.
- Slide the throttle lever up about 1/3 of
the way toward the fast positon.
Pressure built up in the high pressure
washer.
- Squeeze the trigger to release the
pressure.
I
or additional
engine problems
refer
to the engine owners manual.
Unit does not reach high pressure.
• Diameter
of garden hose is too small.
Replace with a 3/4 inch garden hose.
• Water supply is restricted.
- Check garden hose for kinks, leaks
and blockage.
• Not enough inlet water supply.
- Open water source full force.
• Water inlet filter is clogged.
Remove filter and rinse out in warm
water.
• Black detergent
nozzle is attached.
Remove black detergent nozzle and
attach a high pressure nozzle.
Output pressure Varies high and low'
= Not enough inlet water supply.
- Turn water on full force. Check garden
hose for kinks, leaks or blockage.
Pump is sucking air.
- Check that hoses and fittings are air
tight. Turn off machine and purge
pump by squeezing trigger gun until a
steady flow of water emerges through
the nozzle.
Water inlet filter is clogged.
- Remove filter and rinse out in warm
water.
Spray nozzle is obstructed.
- Blow out or remove debris with a fine
needle.
Calcified gun, hose or spray wand.
- Run distilled vinegar through
detergent suction tube.
No detergent.
• Detergent suction
tube not properly
connected
to the machine.
- Check connection.
Detergent is too thick.
- Dilute detergent.
For best results, use
K_rcher detergent.
Detergent filter valve is at lowest
setting.
- Set detergent filter valve to a higher
setting.
Filter on detergent
suction
tube is
clogged.
- Run warm water through filter to
remove debris.
Damaged or clogged
detergent
suction tube.
- Remove obstruction
or replace
detergent suction tube.
A high pressure nozzle is attached.
- Replace with black detergent nozzle.
Spray nozzle is obstructed.
- Blow out or remove debris with fine
needle.