Tennant T260 Manual Del Operador página 12

English
3. Place the brush plate in the
center of the brush plate cover, hold
the brush plate upward with both
hands in balance, and put one pin
on the brush plate into the brush
buckle installation hole through
the observation port, and shake it
from side to side, so that the other
two pins also enter the hole of
the brush buckle. When the brush
plate is balanced, then immediately
forcefully rotate counterclockwise,
and snap into the brush buckle
by inertia (as shown in the picture
below).
For safety: When using the
machine, please follow the mixing
ratio and the instructions on the
chemical container.
Pour the Solution Into the Solution
Tank
The front of the machine is
equipped with a bucket water
injection hole, and the solution is
injected into the solution tank (as
shown in the picture below).
12
For scrubbing method: use warm
water (maximum 60°C). Pour the
recommended detergent into the
solution tank for mixing.
Note: If you pour the solution into
the solution tank with a bucket,
make sure that the bucket is clean.
Do not use the same bucket for
filling solution and discharging
sewage.
Note: For scrubbing method, please
always use the recommended
commercial detergent. If the
machine is damaged due to
improper use of detergent,
(remember not to use granular
detergent, such as washing
powder), the manufacturer will not
be responsible for the warranty.
Warning: Pay attention to the risk
of fire or explosion, and do not use
flammable liquids.
Tennant T260 (10- 2023)