Descargar Imprimir esta página

Sears Craftsman 917.379300 Manual página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGINE
CARBURETOR
Your carburetor has a non-adjustable fixed
mainjet for mixturecontrol, If your engine
does not operate properlydueto sus-
pectedcarburetor problems,take your
lawn mowerto an authorizedservice
centerfor repair or adjustment.
ENGINE
SPEED
Your engine
speed
has been factory
set.
Do not
attempt
to increase
engine
speed
or it may result in personal
injury.
If you
believe
that the engine
is running
too fast
or too slow, take your lawn mower to an
authorized
service
center for repair and
adjustment.
Immediately
prepare your lawn mower for
storage at the end of the season or if the unit
will not be used for 30 days or more_
LAWN MOWER
When fawn mower is to be stored for a period
of time, clean it thoroughly,
remove all dirt,
grease, leaves, etc. Store in a clean, dry area.
o Clean entire lawn mower (See "CLEANING"
in the Customer
Responsibilities
section of
this manual).
• Lubricate as shown in the Customer
Responsibilities
section of this manual.
• Be sure that all nuts, bolts, screws, and pins
are securely fastened.
Inspect
moving
parts for damage, breakage
and wear.
Replace if necessary°
• Touch up alt rusted or chipped paint
surfaces;
sand lightly before painting_
HANDLE
You can fold your lawn mower handle for
storage.
• Squeeze
the bottom ends of the lower
handle toward each other until the lower
handle clears the handle bracket, then
move handle forward.
° Loosen
upper handle mounting bolts
enough to allow upper handle to be folded
back.
IMPORTANT:
When folding the handle for
storage or transportation,
be sure to fold the
handle as shown or you may damage the
control cables°
° When setting up your handle from the
storage position, the lower handle wilt
automatically
lock into the mowing position.
Lower __'--..,.
Handle
Handte/_._.._
Bracket
Squeeze t_,fol__...
Cotter
Operator Presence
Control Bar
Upper Handle "" _
,_//_-
/
//
,
,,11
.'4_%Fold
Backward
)
Mowing Position
Fold Forward
ForStorage
ENGINE
FUEL SYSTEM
Lower Handle
IMPORTANT: It is important to prevent bum
deposits from forming in essential juel system
parts such as carburetor, fuel filter, fuel hose,
or tank during storabe. Also, experience
indicates that alcolol blinded fuels (called
gasohol or using ethanol or methanol) can
attract moisture which leads to separation and
formation of acids during storage° Acidic gas
can damage the fuel system of an engine
while in storage.
• Drain the fueltanK
• Start the engine and let it run until the fuel
lines and carburetor are empty.
° Never use engine or carburetor cleaner
products in the fuel tank or permanent
damage may occur.
o Use fresh fuel next season°
NOTE: Fuel stabilizer is an acceptable
alternative in minimizing the formation of fuel
gum deposits during storage. Add stabilizer to
gasoline in fuel tank or storage container.
Always follow the mix ratio found on stabilizer
container. Run engine at least 10 minutes
after adding stabilizer to allow the stabilizer to
reach the carburetor. Do not drain the gas
tank and carburetor if using fuel stabilizer.
ENGINE OIL
Drain oil (with engine warm) and replace with
clean engine oil. (See "ENGINE" in the
Customer Responsibilities section of this
manual).
15

Publicidad

loading