Publicidad
Idiomas disponibles
Idiomas disponibles
o Withan ! 1/16"or adjustablewrench,
loosenjam nut A severalturns to clear
adjustmentnut B.
. Witha 3/4" or adjustablewrench,turn
front linkadjustmentnut (B)clockwise
(tighten)to raisethe front of mower,or,
counterclockwise (loosen)to lowerthe
front mower.
NOTE: Eachfull turn of the adjustment
nut will changemowerheightabout1/8".
° Recheckmeasurements, a djustif nec-
essaryuntilfronttip of bladeis 1/8"to
'I/2" lower than the rear tip.
- Hold adjustment
nut in position with
wrench
and tighten jam nut securely
against
adjustment
nut_
Tighten adjust
nut
B to raise mower
Loosen adjust nut
B to lower mower
Loosen jam nut A first
TO REPLACE
MOWER
DRIVE
BELT
MOWER
DRIVE
BELT REMOVAL
1
Park tractor
on a level surface.
Engage
parking
brake.
2.
Lower attachment
lift lever to its lowest
position°
3.
Remove
any dirt or grass clippings
which may have accumulated
around
mandrels
and entire upper deck sur-
face.
4o Remove
belt from electric
clutch pulley
(M), both mandrel
pulleys
(R) and all
idler pulleys
(S).
MOWER
DRIVE
BELT INSTALLATION
1.
Install belt around
all mandrel
pulleys
(R) and around
idler pulleys
(S) as
shown,
2,
Install belt onto electric
clutch pulley
(M).
IMPORTANT:
Check
belt for proper
rout-
ing in all mower pulley grooves,
3. Raise attachment
lift lever to highest
position.
23
TO CHECK
BRAKE
If tractor
requires
more than five (5) feet to
stop at highest
speed in highest
gear on a
level, dry concrete
or paved surface,
then
brake must be serviced.
You may also check
brake by:
1o Park tractor
on a level, dry concrete
or
paved surface,
depress
clutch/brake
pedal all the way down and engage
parking
brake.
2.
Place gear shift lever in neutral
(N)
position.
The rear wheels
must lock and skid
when you try to manually
push the tractor
forward.
If the rear wheels
rotate, then the
brake needs to be serviced.
Contact
a
Sears
or other qualified
service
center.
TO REPLACE
MOTION
DRIVE
BELT
Park the tractor
on level surface.
Engage
parking
brake_
For assistance,
there is a
belt installation
guide decal on bottom
side
of left footrest,,
BELT REMOVAL
-
1o Remove
mower
(See "TO REMOVE
MOWER"
in this section
of manual),
NOTE:
Observe
entire
motion drive belt
and position of all belt guides and keepers,
2.
Remove
belt from stationary
idler (A)
and clutching
idler (B).
3_ Remove
belt from centerspan
idler (C).
4o Pull belt slack toward
rear of tractor,
Remove
belt upwards
from transaxle
input pulley (D).
5.
Remove
bert downward
from engine
pulley (E),
Publicidad
