Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
CHART:
See appropriate
section
in manual
unless
directed
to Sears service
center
PROBLEM
Will not start
Hard to start
Engine
will not
turn
over
Engine
clicks but
will not start
Loss
of power
CAUSE
CORRECTION
1o Out of fuel.
2.
Engine
not"CHOKED"
properly.
3,
Engine flooded.
4,
Bad spark plug,
5,
Dirty air filter.
6,
Dirty fuel filter,
7
Water in fuel.
8.
Loose or damaged
wiring,
9.
Carburetor
out of adjustment,
10,, Engine valves out of
adjustment
1, Dirty air filter°
2,
Bad spark plug.
3,
Weak or dead battery.
4.
Dirty fuel filter,
5, Stale or dirty fuel
6,
Loose or damaged
wiring.
7,
Carburetor
out of adjustment.
8. Engine valves out of
adjustment.
1. Clutch/brake
pedal not
depressed,
2, Attachment clutch is engaged,
3o Weak or dead battery°
4.
Blown fuse,
5.
Corroded
battery terminals.
6_ Loose or damaged
wiring.
7,
Faulty ignition
switch.
8.
Faulty solenoid
or starter.
9.
Faulty operator
presence
switch(es).
1. Weak or dead battery.
2.
Corroded
battery terminals.
3o Loose or damaged
wiring.
4_ Faulty solenoid
or starter.
14 Cutting
too much grass/too
fast.
2. Throttle
in "CHOKE"
position.
. Fill fuel tank.
, See "TO START
ENGINE"
in Operation
section.
3, Wait several
minutes
before attempting
to start,
4,
Replace
spark plug.
5. Clean/replace
air filter,
6.
Replace
fuel filter,
7.
Empty fuel tank and carbure-
tor, refill tank with fresh gas-
oline and replace
fuel filter,
8o Check all wiring.
9.
See "To Adjust Carburetor"
in Service and Adjustments
section°
10, Contact
a Sears or other
qualified
service
center.
i.
Clean/replace
air filter,
2.
Replace
spark plug_
3. Recharge
or replace
battery,
4.
Replace
fuel filter.
5. Empty fuel tank and refill tank
with fresh, clean gasoline,
6. Check all wiring.
7o See "To Adjust
Carburetor"
in Service
and Adjustments
section,
8o Contact
a Sears or other
qualified
service
center
1o Depress
clutch/brake
pedal.
2. Disengage attachment clutch°
3.
Recharge
or replace
batter,/,
4_ Replace fuse,
5. Clean battery
terminals,
6. Check all wiring.
7. Checktreptace ignition switch.
8, Checklreplace
solenoid
or
starter,,
9. Contact
a Sears or other
qualified
service
center.
1.
Recharge
or replace
battery.
2. Clean battery
terminals.
3o Check all wiring.
4. Checktreplace
solenoid
or
starter.
1.
Raise cutting
height/reduce
speed,
2. Adjust throttle
control,
28
Publicidad
