Ryobi PBLSV747 Manual Del Operador página 6

INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 9.
„ Insert the battery pack into the product as shown.
„ Make sure the latches on each side of the battery pack
snap into place and that battery pack is secured in the
product before beginning operation.
„ Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
REMOVING AND FILLING THE CLEAN TANK
See Figure 3, page 9.
Use the included cleaning formula to fill the clean tank.
NOTICE:
Use only RYOBI Hard Surface Cleaning formula. Do not
use other chemicals as this may damage the internal
parts of the unit and void your warranty.
„ Remove the battery pack.
„ Push clean tank release button to remove tank from back
of the vacuum.
„ Lift the door on top of the tank and fill with water up to
the water fill line.
„ Add the RYOBI Hard Surface Cleaning formula until the
water solution reaches the formula fill line.
NOTE: Wipe off any excess solution that may have spilled
onto the outside of the tank.
„ Close the clean tank door.
„ Insert tank back into vacuum and click into place.
NOTE: Be sure the tank is installed properly to avoid
any leakage.
STARTING/STOPPING THE WET/DRY STICK
VACUUM
See Figure 4, page 9.
WARNING:
To reduce the risk of fire or explosion, do not leave the
product running while unattended. Immediately stop the
unit if it shows signs of abnormal operation such as loss
of suction, liquid or debris in the exhaust, or any abnormal
motor noises.
To start the vacuum:
„ Depress the ON/OFF button to turn on the vacuum.
„ Step on the vacuum roller head and recline the vacuum
handle back to start dispensing the solution on the roller
bar.
OPERATION
To stop the vacuum:
„ Depress the ON/OFF button to turn off the vacuum.
„ Return the handle to the upright position.
MAX SUCTION BUTTON
See Figure 4, page 9.
„ Press the MAX button to increase the amount of suction.
„ Press the MAX button a second time to return the suction
to normal operation.
SOLUTION PUMP BUTTON
See Figure 4, page 9.
„ Press the solution pump button to stop the water solution
from being dispensed on the roller bar.
„ Press the solution pump button a second time to restart
dispensing the solution on the roller bar.
USING THE WET/DRY STICK VACUUM
See Figures 5 -6, page 10.
This product is intended for use on hard surfaces only. Do
not use on carpet.
„ Roll the vacuum to the item or surface you want to clean.
„ Insert the battery pack and start the vacuum.
„ Select the appropriate mode for the surface you are
cleaning.
NOTE: If necessary, step on the back of the floor head
and pull back on the handle to recline and begin cleaning.
„ When cleaning is complete, stop the unit and remove
the battery pack.
DRY VACUUMING
See Figure 7, page 10.
Vacuum only items small enough to fit through the vacuum
hose. The performance of the wet/dry vacuum will decrease
with a full dirty tank. When emptying the dirty tank, check
to see if the filter needs cleaning.
CAUTION:
In low relative humidity conditions, vacuuming fine debris
with the wet/dry vacuum can cause a static charge result-
ing in static shock. To reduce static shock while using,
add moisture to the air with a humidifier.
WET VACUUMING
See Figure 8, page 10.
When wet vacuuming, be aware that the wet/dry vacuum
is equipped with a water float inside the filter unit housing.
This water float is designed to shut off the suction when the
dirty tank reaches full wet capacity. When the dirty tank is
full, turn the wet/dry vacuum OFF and empty the dirty tank.
6 — English