Ryobi PBLSV747 Manual Del Operador página 7

EMPTYING THE DIRTY TANK
See Figures 9 - 11, page 11.
„ Push dirty tank release button to remove tank from front
of vacuum.
„ Pull filter unit housing up and out of dirty tank.
„ Empty dirty tank.
„ Replace filter unit housing.
„ Insert tank back into vacuum and click into place.
NOTE: Be sure the tank is installed properly to avoid
any leakage.
LED LIGHT FUNCTIONS
When a charged battery pack is installed in the appliance, the LED lights will indicate the status of the appliance when the
appliance is powered on.
STATUS
Power ON
Battery < 50%
Battery Low
Self-clean Mode
Overspin
Dirty tank Full
MAX Suction Mode
Solution Pump ON
Roller Bar Jam
OPERATION
When vacuuming liquid, make sure the wet/dry vacuum
or battery does not get submerged or doused in liquid,
which could cause shock, vacuum failure, or personal
injury.
Do not allow liquid pick up to remain in the dirty tank for
extended periods of time. Moisture can develop in the
motor compartment and shorten the life of the motor.
Do not turn unit upside down, as liquid may enter the
motor unit.
LED
Green LEDs, #1 and #2
Green LED, #1
Red LED, #1
Self-clean and Solution Pump LEDs
Red Tank Full LED
Red Tank Full LED
White MAX Mode LED
White Solution Pump LED
Red Roller Housing LED
7 — English
WARNING:
CAUTION:
CAUTION:
ON
ON
ON
ON
Blinks 6 Times, Then Shutdown
Blinks 6 Times, Then Shutdown
ON
ON
ON, Roller Shutdown
ACTION