Publicidad
Idiomas disponibles
Idiomas disponibles
Box content
-
Fan body
Assembly kit
-
-
Instruction manual
3. PRODUCT ASSEMBLY
The following tools are required to carry out the installation: screwdriver, flat-head screwdriver,
adjustable pliers or wrench, stepladder, wire cutter, epoxy resin, and rated electrical tape.
Warning
To avoid electric shocks, turn the household power supply off before installing the ceiling fan.
General assembly instructions
If you hang the fan on a hook, the latter must withstand at least 100 kg.
Assembly according to the type of ceiling. (Fig. 2):
1. Low ceilings
2. Normal ceilings
3. Sloped ceilings (might require a longer downrod, not supplied by Cecotec)
To assemble this ceiling fan, follow the steps below (Fig. 3-12):
1. Remove the lower and upper pins from the downrod and release the hanging ball at the
top of the rod.
2. Pass the wiring from the main body through the downrod.
3. Attach the downrod to the main body by inserting the pin through the downrod and the
main-body attachment. Tighten the screws provided on the main-body attachment to
properly secure the downrod.
4. Remove the 4 screws that fix the upper canopy and the installation bracket. Insert the
upper canopy through the downrod. Fig. 3
5. Insert the pin through the pin holes located on the upper end of the downrod. Once
inserted, slide the hanging ball upward to the upper end of the downrod and fix it with one
of the screws provided.
6. Make sure the pin fits in the slots located inside the hanging ball before screwing it.
7. Mark the centre of the installation bracket and use both self-tapping screws provided
with their corresponding washers and pressure washers to fix the installation bracket to
a wooden ceiling.
ENERGYSILENCE AERO 360 & 365
ENGLISH
35
Publicidad
