Publicidad
Idiomas disponibles
Idiomas disponibles
Close the washer door by pushing it firmly until the lock
clicks. The washer door will remain locked during the wash
cycle.
NOTE: After any wash cycle is completed, the door must be
opened and then closed before a new cycle can begin. The
door can be opened only if PAUSE/CANCEL is selected while
the ADD A GARMENT light is glowing or if the cycle has been
canceled. See "To cancel a cycle" in "Changing Cycles,
Options and Modifiers" section.
3. Open the dispenser drawer and add laundry additives to the
detergent, bleach, or fabric softener compartments.
Close
drawer slowly to avoid spills. See "Using the Dispenser."
4. Turn on the washer by selecting one of the WASH CYCLES.
The indicator light for the selected cycle will glow. When
selecting a Wash Cycle, the preset options, Water Temp, Spin
Speed, and Soil Level for the selected cycle will glow. The
display shows the estimated time remaining. The preset
settings provide the recommended
fabric care for the
selected cycle. See "Cycles."
5. Select the desired OPTIONS. Not all Options are available
with all cycles. See "Options."
6. Select the desired MODIFIERS. Not all Modifiers are available
with all Cycles and Options. See "Modifiers."
7. If desired, select the END OF CYCLE SIGNAL. The signal is
helpful when you are washing items that should be removed
from the washer as soon as it stops. Select ON or OFR
8. To begin the wash cycle immediately
Select and hold START (for approximately
1 second).
•
If you do not select START within 5 minutes of choosing a
cycle, the washer automatically
shuts off.
•
When the wash cycle is complete, the CLOTHES CLEAN
status light glows, the door unlocks, and the wash load
can be removed from the washer. The washer powers
down automatically
5 minutes after the cycle is complete
and the CLOTHES CLEAN light goes off. To power down
the washer manually after the wash cycle is complete,
select PAUSE/CANCEL once.
To begin the wash cycle later
Select DELAY until the desired delay time (in hours) shows in
the Estimated Time Remaining display. Select START. The
countdown to the wash cycle will show in the display window.
IMPORTANT: When delaying a cycle, use only powdered
detergents in the main wash compartment
since liquid
detergents may seep out of the compartment
during Delay,
before the wash cycle begins.
Your new washer has a dispenser drawer with four separate
compartments
for your laundry additives--two
are for detergent,
one is for liquid chlorine bleach, and one is for liquid fabric
softener. Laundry additives are diluted and dispensed
automatically at the proper time during the wash cycle, making it
unnecessary for you to return to the washer during the cycle to
add them.
It is normal for small amounts of water to remain in the
dispensers when the wash cycle is complete.
Do not put laundry additives directly into the wash tub. Always
use the proper dispensers when adding laundry additives.
Choosing
the Right Detergent
Use only High Efficiency detergents. The package for this type of
detergent will be marked "HE" or "High Efficiency." This wash
system, along with less water, will create too much sudsing with a
regular non-HE detergent. Using regular detergent will likely result
in washer errors, longer cycle times and, reduced rinsing
performance.
It may also result in component
failures and
noticeable mold or mildew.
HE detergents are made to produce the right amount of suds for
the best performance.
Follow the manufacturer's
instructions
to
determine the amount of detergent to use.
Use only "HE" High Efficiency detergent.
To fill dispenser compartments
1. Pull out the dispenser drawer.
2. Add the desired laundry product to the proper compartment.
3. Push in the dispenser drawer slowly and completely (to avoid
a spill).
F
Dispenser
A. Prewash detergent compartment
B. Separator
C. Main Wash detergent
compartment
D. Dispenser release lever
E. Chlorine bleach compartment
F Fabric softener compartment
Prewash detergent
compartment
(Letter A in Dispenser Illustration)
Add detergent to this compartment
when using the Prewash
option or Soak cycle. Liquid or powdered detergent may be used
in this compartment.
The detergent will automatically
be
dispensed during Prewash, if the Prewash option is selected, or
during the soak time if Soak is selected.
•
Using only High Efficiency (HE) detergent, add 1/3 the
recommended
amount to the prewash compartment
and %
the recommended
amount to the main wash compartment.
Main Wash detergent
compartment
(Letter C in Dispenser Illustration)
Add liquid or powdered HE detergent to this compartment
for
your main wash cycle. The detergent separator must always be in
place, either in the front or back position.
IMPORTANT:
If you are using the Prewash, Soak or Delay option,
powdered detergent must be used in the main wash
compartment
since liquid detergents may seep out of the main
wash compartment,
before the main wash begins.
•
Do not fill beyond the "MAX" level. Use detergent
manufacturer's
recommended
amount for load size.
13
Publicidad
