Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Do not probe the charger.
u
$
The charger is intended for
indoor use only.
#
Electrical safety
Your charger is double insu-
lated; therefore no earth wire
is required. Always check that
the mains voltage corresponds
to the voltage on the rating
plate. Never attempt to replace
the charger unit with a regular
mains plug.
If the supply cord is damaged,
u
it must be replaced by the
manufacturer or an authorised
STANLEY FAT MAX Service Centre
in order to avoid a hazard.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
Labels on appliance
The following symbols appear on this appliance along with the
+
date code:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
Features
This tool includes some or all of the following features.
1
ON/OFF button
2
Variable power switch
3
Main handle
4
Floor brush ON/OFF button
5
Vacuum inlet
6
Extension tube
7
Accessory release latch
8
Filter agitator wheel
9
Lift away dust canister
10 Floor brush
11 LED worklight
12 6" brush tool
13 Crevice tool
14 Battery pack
20
(Original instructions)
15 Battery release button
Assembly
Charging the battery (not supplied) (Fig. A)
The battery needs to be charged before first use and
whenever it fails to produce sufficient power on jobs that were
easily done before.
The battery may become warm while charging; this is normal
and does not indicate a problem.
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C. Recommended charging
temperature: approx. 24 °C.
Note: The charger will not charge a battery if the cell
temperature is below approximately 10 °C or above 40 °C.
The battery should be left in the charger and the charger
will begin to charge automatically when the cell temperature
warms up or cools down.
Note: To ensure maximum performance and life of lithium-ion
battery packs, charge the battery pack fully before first use.
u Plug the charger (26) into an appropriate outlet before
inserting battery pack (14).
The green charging light (26a) will blink continuously
u
indicating that the charging process has started.
The completion of charge will be indicated by the green
u
charging light (26a) remaining ON continuously. The
battery pack (14) is fully charged and may be removed
and used at this time or left in the charger (26).
Charge discharged batteries within 1 week. Battery life will
u
be greatly diminished if stored in a discharged state.
Charger LED Modes
Charging:
Green LED Intermittent
Fully Charged:
Green LED Solid
Hot/Cold Pack Delay:
Green LED Intermittent
Red LED Solid
Note: The compatible charger(s) will not charge a faulty
battery pack. The charger will indicate a faulty battery pack by
refusing to light.
Note: This could also mean a problem with a charger. If the
charger indicates a problem, take the charger and battery
pack to be tested at an authorized service centre.
Leaving the battery in the charger
The charger and battery pack can be left connected with the
Publicidad
