Publicidad
Idiomas disponibles
Idiomas disponibles
6, Removekeyfrombag andstart the
engine(see"TOSTARTENGINE"in
the Operationsectionof this manual).
After enginehas started,movethrottle
controlto idle position.
7. Releaseparkingbrake.
8, Slowlydepressforwarddrivepedaland
drivetractoroff skid,
9o Applybraketo stoptractorandset
parkingbrake,
"STOP"
10.Turnignitionkey to
position°
Continuewith the instructionsthatfollow.
ASSEMBLE
FRONT WHEEL TO
MOWER
1. Using shoulder bolt, washer and
Iocknut from parts bag, assemble front
wheel to mower as shown.Tighten
securely_
NOTE:
Be sure mower side suspension
arms (A) are pointing
forward before slid-
ing mower under tractor.
4.
Slide mower under tractor until it is
centered
under tractor.
5o FIRST
INSTALL ANTI-SWAY
BAR (S)o
- From right side of mower, insert
ant-sway
bar into hole in transmission
bracket
(T)o
iNSTALL
MOWER
AND
DRIVE
BELT
See MOWER
AND DRIVE BELT AS-
SEMBLY
Supplement
Sheet for additional
guidance
on this assembly.
Be sure tractor
is on level surface and
engage
parking
brake.
!.
Lower attachment
lift lever to it's lowest
position,
_, CAUTION:
Lift Sever is spring
loaded.
Have a tight grip on lift lever, lower it
slowly
and engage in lowest position.
2.
Turn steering
wheel
to the left as far as
it will go and position
mower on right
side of tractor with deflector
shield to
the righL
- Pivot bar towards
you and insert other
end of bar into hole in rear mower
bracket
(D)o Move mower as needed to
insert barn
- Secure
with washer and retainer
spring
as shown,
3_
Remove
plastic tie securing
belt, bring
belt forward and check belt for proper
routing
in all mower pulley grooves.
6_
7_
9
ATTACH MOWER
SIDE SUSPENSION
ARMS (A)TO
CHASSIS
- Position
hole
in arm over pin (B) on outside
of tractor
chassis
and secure with washer
and
retainer
spring.
Repeat
on opposite
side of tractor.
Publicidad
