GreenWorks Commercial 82TB161 Manual Del Operador página 12

EN
10.6 REMOVE THE TRIMMER HEAD
1. Put the metal rod (E) in the specified angle transmission
hole (D) to fix the trimmer head.
2. Remove the spool cover and the spool.
3. Loosen the nut (J) on the trimmer head clockwise with a
wrench.
4. Remove the trimmer head.
10.7 ASSEMBLE THE TRIMMER HEAD
1. Put the trimmer head onto the housing.
2. Install the nut.
3. Put the metal rod in the specified angle transmission hole
to fix the trimmer head.
4. Tighten the nut on the trimmer head counterclockwise
with a wrench.
You must install the cut-off blade when you use the trimmer
head.
10.8 REMOVE THE BRUSH CUTTER
Apply the guard to the blade.
20
21
J
22
D
E
IMPORTANT
WARNING
English
1. Put the meatal rod (F) in the specified angle transmission
hole (D) to fix the trimmer head.
2. Loosen the nut (J) clockwise and remove the outer cup
(I).
3. Remove the plate (H) and brush-cutter blade.
4. Remove the inner cup (F).
10.9 ASSEMBLE THE BRUSH CUTTER
Wear gloves and be careful with sharp edges.
Apply the guard to the blade.
Use the specified Nylon locknut which is packed with the
blade, to assemble the blade.
You must change the locknut after you use it for 20 times.
1. Put the metal rod (E) in the specified angle transmission
hole (D) to fix the trimmer head.
2. Put the inner cup (F) onto the center shaft.
3. Put the brush-cutter blade (12) on top of the inner cup.
Make sure the blade is in the center.
4. Put the plate (H) above the blade.
5. Put the outer cup above the plate (I).
6. Put the locknut above the outer cup.
7. Tighten the lock-nut (J) counter-clockwise to 44-58" N.M
of torque with a 19mm wrench.
12
J
WARNING
WARNING
WARNING
WARNING
12
D