Publicidad
Idiomas disponibles
Idiomas disponibles
Adjusting the balance
Adjusting the shoulder harness
This product is designed to fit a wide variety of body sizes, but may not be adjustable for extremely tall persons. Do
not use the unit if your feet can reach the cutting attachment when the unit is attached to the harness.
A person's size can affect the balancing adjustment. Also the balancing procedure may not work with some units on some
persons. If the shoulder harness does not fit you or cannot be adjusted well, please ask your dealer for assistance.
Balance tool for a level plane of cutting head rotation
1.
Inspect blades (A) before installation. Check for sharpness.
Dull blades increase the risk of blade kickback reactions.
Small cracks can develop into fractures resulting in a piece
of blade flying off during operation. Discard cracked blades
no matter how small the crack.
2.
Insert locking tool (B) into a hole located on the right side of
angle transmission while forcing retainer spring to the left
side.
3.
Insert locking tool further into blade retainer fixing slot (C) to
fix output shaft.
4.
Using the socket wrench, remove the nut (D), cup (E), and
lower blade retainer (F).
5.
Securely tighten the blade, lower blade retainer, cup, and nut
by hand.
Fix output shaft securely using locking tool in order to
prevent it form rotating when blade is mounted. Other-
wise, the blade fastening nut will not be tightened suffi-
ciently.
6.
Tighten the nut (turn anticlockwise) using a socket wrench.
Never fasten while applying your weight. Otherwise the
thread of nut could be broken.
7.
Remove locking tool.
WARNING
IMPORTANT
The accompanying shoulder harness is suitable for people of
standard adult physique, who are 150 cm - 195 cm in height
and 60 cm - 120 cm in waist size.
Use a shoulder harness when provided or when recommend-
ed in this manual. Adjust both harness and the suspension
point (A) on the unit so the unit hangs with the cutting attach-
ment a few centimetres above ground level (B).
The cutting attachment and shield should be level in all direc-
tions. Harness the unit on the right side as shown.
13
Before you start
CAUTION
Publicidad
