Publicidad
Idiomas disponibles
Idiomas disponibles
ENGINE
CONNECTOR
(MALE)
BATTERY CONNECTOR
(FEMALE)
BATTERY
CHARGER
BATTERY
CHARGER
CONNECTOR
(MALE)
FIG. 2
TO ASSEMBLE
AND ATTACH GRASS
CATCHER
(See Figs.
3A thru 4)
•
Insert leg of tubular frame through front openi_ng of
grass catcher and thread frame into sewn hem Ib_of ag.
NOTE: Keep bag hem gathered on the straight leg of the
tubular frame°
•
When frame comes out the other end of sewn hem,
immediately work the end of frame down inside the bag
as shown in inset,,
°
Slide sewn hem evenly around the tubular frame until
both ends of frame are exposed out of the front open-
ing,,
°
Assemble lower frame to tubular frame as shown° Be
sure handle is outside of bag and frames are fully
seated as shown in inset°
•
Slip vinyl bindings over frame_
NOTE: If vinyl bindings are too stiff, hold them in warm
water for a few minutes_ If bag gets wet, let it dry before
using.
•
Close the flip lid,. Flip lidmust be closed while operating
lawn mower,,
•
Lift the rear door on the mower housing and place the
grass catcher frame onto the formed tabs on the rear
door hinge bracket.
°
The grass catcher is secured to the lawn mower
housing when the rear door is lowered onto the grass
catcher frame.
,HmHUlI,
............................
_
CAUTION: Do not runyourlawn mower
without clipping deflector or approved
grass catcher in place. Never attempt
to operatethe lawn mower with the rear
door removed or propped open.
wul,
TUBULAR FRAME
SEWN
SEWN HEM
FIG, 3A
FLtP LID
LOWER
"_
_.o-
/
FRAME
_*
_,j"
_
//
It
(Frames must
i
//
