23 / EN
IV.- INSTALLATION OF YOUR HEATER
HEATER LOCATION
F
r o
o
t p
m i
l a
p
e
f r
r o
m
recommend not more than a 5 meters' distance). This will minimize the loss of heat and pro-
vide hot water quickly at the point of use.
•
This heater must be installed horizontally, with the connections facing downward to
operate properly. When the installation is finished and before filling it with water and
testing instrument (such as a bubble level) (see Fig. 2).
•
Install your heater so that the control panel is not obstructed, to facilitate operation and
maintenance. Leave a free space of at least 50 cm for access to the electrical parts.
•
The location of your heater should be as practical as possible, near the areas where hot
water is used in order to avoid heat loss or freezing in areas of extreme cold.
•
This water heater should be installed indoors or in enclosed spaces, because it does
not require ventilation for its operation.
•
If it is installed outdoors, the heater requires protection against the rain, preferably a
roof at a minimum of 80 cm from the heater top. If the heater is not protected from the
rain, this could damage the equipment and the electrical installation, making void the
warranty.
•
The heater must be perfectly fixed to avoid movement during earthquakes and/or
tremors, in order to prevent it falling from its position. It must also be protected by a
roof or niche to avoid direct contact with the rain.
•
The heater must be installed far from flammable materials or spaces with strong
magnetic fields.
FOR INSTALL YOUR HEATER
•
Remove the two (2) screws that fasten the front cover on the water heater
(see Fig. 3B). Remove the front cover (see Fig. 3A).
•
The surface where the heater will be installed must be solid and secure. DO NOT install
the unit over. connections or electrical boxes.
•
Place the heater on the surface where it will be installed. Check that it is leveled.
a
c n
, e
l p
c a
e
h t
e
h
e
t a
r e
s a
c
o l
e s
s a
p
o
s s
b i
e l
o t
h t
e
p
o
n i
s t
f o
u
e s
w (
e